All equipment, after fitting, is subjected to blank functional tests, simulating real working conditions, where possible, in order to certify equipment's compliance, tolerances and performances.
List of tests we made
After these tests, the following quality controls are implemented.
Correct assembly according to parts plan
Dimensional check of the outside dimensions for the open and closed machine's positions
Most important characteristics and premises control
Hydraulic circuit's control and pressure verification
Air bubbles purging throughout the hydraulic installation
Hydraulic cylinders pressure tests (300 bar).
Level check
Interlocking and triggering system operating tests
Control of synchronism and mechanical transmission systems
Arm, claw or valve movement uniformity control
Control of the correct closure of nails, mouths, teeth, clamps or claws
Control of the electrical circuit
Carrying out of the different movements of the machine while empty
Measuring of closing and opening times while empty
Temperature control (The thermostat must not be activated after 200 uninterrupted cycles).
Operational control of pressure switches, end of runs, sensors and other accessories
Greasing of lubricated organs, components and joints
Checking the absence of vibrations, rubbing and strange noises
Revision of gaps in all joints
